GE Measurement & Control Solutions Moisture Target?Series 6 Moisture Analyzer Features ? Low-cost, single-channel hygrometer for OEM applications ? M Series moisture probe or VeriDri moisture transmitter compatible ? NEMA 4 weatherproof membrane front display/ keypad ? Built-in isolated current or voltage analog output ? MicroSD card for logging data up to 32 GB ? Panel-mount and board-level confi gurations ? Fail-safe fault alarm relay ? Two Form C measurement alarm relays ? Upgrades from MTS5 with adaptor face plate Applications This single-channel analyzer measures moisture in compressed air and gases. Designed for permanent installations, it is used in conjunction with M Series moisture probe or VeriDri moisture transmitter for air/gas dryer original equipment manufacturer (OEM) applications: ? Regenerative desiccant air or gas dryers ? Plastic drying applications prior to injection/ blowmolding ? Medical air dryers ? Glove box monitoring Low Cost, Real-Time Moisture Measurement The Moisture Target Series 6 is an economical, single channel, aluminum oxide hygrometer in the Moisture Series line of analyzers. It is intended for OEM applications requiring low-cost, accurate, real-time moisture measurement. Improves OEM Product Perbance The Moisture Target Series 6 can signifi cantly enhance the perbance of OEM products by allowing closed-loop control of moisture. For example, in a regenerative dryer application it can improve effi ciency by initiating desiccant bed regeneration when needed, rather than on an openloop timed cycle. Panel-Mount The panel-mount Moisture Target Series 6 comes in a compact DIN standard meter housing for applications where space is at a premium. The case slides directly into the panel cutout, and is held in place from the rear by captive screws. The Moisture Target Series 6 can be supplied with a bezel adaptor to allow installation into existing Moisture Target Series 5 panel cut-outs. Uses M Series Probes and VeriDri Transmitter The Moisture Target Series 6 uses M Series aluminum oxide moisture sensor probe or VeriDri moisture transmitter. M Series probes and VeriDri transmitter are rugged and accurate true absolute humidity sensors with calibration traceable to NIST. Exceptional dynamic range, speed of response and calibration stability have made the aluminum oxide sensor the standard for perbance and value in industrial moisture measurement for more than 40 years. Microprocessor-Based Electronics The microprocessor-based Moisture Target Series 6 accuraby tracks fast-changing process conditions and displays dew/frost point temperature in 掳F or 掳C on an LCD. Dew/frost point is also available as an analog voltage or current output, and the Moisture Target Series 6 features built-in isolation to ensure the integrity of signals to remote devices. The unit also features two Form C alarm relays for high and low dew/frost point limits. The microprocessor-based electronics and six-button keypad combine to make selection of analog output zero and span, alarm setpoints fast and easy, and entry of calibration data sample. Series 6 Specifi cations Electronics Intrinsic Safety External safety barrier for moisture b (optional) European Compliance Complies with EMC Directive 2004/108/EC and 2006/95/EC Low Voltage Directive (Installation Category II, Pollution Degree II) Input Moisture signal from GE Sensing thin-fi lm aluminum oxide moisture sensor on an M Series probe or VeriDri transmitter
